This 3D-printed desk organizer is designed to work with Gridfinity by Zack Freedman, and the module inspiration comes from my original desk organizer system.

Each module in this project is 6U tall and fits perfectly on 2x4 Gridfinity frames. No supports are required.

I printed the modules in Jessie PLA at a .25mm layer height and 15% infill with a .4mm nozzle.

Modules

Last updated on 12/19/23

• EDC
  • Wallet / Cards Module
  • Phone Module
  • Catch-All Wave Module
• Writing
  • Pen / Pencil Module - Large
  • Pen / Pencil Module - Small
  • Pen + Compartment Module
  • Post-it Module
• Compartments
  • 2  - Compartment Module
  • 3  - Compartment Module
  • 8 + 1  - Compartment Module
• Accessories
  • SD Card / Micro SD Card Module
  • USB Module - Large
  • USB Module - Small

Get notified when I release new modules. Sign up for my e-mail newsletter. 

Additional accessories:

-   These slot into the magnet holes in each module's bottom and the baseplate's holes. I opted not to use them in my build. But if you have top-heavy objects in your modules, they may help them stay put during everyday use.

• **Rubber bumper pads for feet of baseplates
  • These bumper pads are perfect for the feet of the baseplates. They have enough grip that I didn't need to add magnets or weights to my baseplates to keep the bases in place during regular use.

To complete this project as pictured:

• Two simple boxes featured in the picture that are not part of my project are from Max's Gridfinity bins - height 6 (42mm). They are the w1_d2_h6_c1_Fingerslide.stl files.
• The Gridfinity frames I used are from RIP_Plo-Koon's Gridifinity Magnet Light Baseplate. I printed two of the Gridfinity Magnet Light Baseplate 2x4.3mf models.