This is just a simple Allen Key Holder that you can mount on the top of your Prusa Printer to have them ready at all times.

There are four Versions available. One for a tighter Fit of the Hex-Mount and one for a loose one. I recommend the Tight one because the Holder doesn't fall off as easy.
There is also a Version where the Holder is at the Back for when the Printer is in a tight Space. You can use this Version for both the left and the right Side of the printer.
The normal Verion is also available as a Left Side Version.

I have uploaded all the .3MF, .GCODE and the .STL files.

Modeled in SolidWorks.

Please Contact me if you have suggestions or questions about this project!!!

Print instructions

Supports are not necessary.

Print with 10 % Infill.

Print the Top Part with lower Layer height than the rest to get smooth finish. (e.g. Bottom at 0.15 mm and Top at 0.1 mm)