Naar de inhoud
Inloggen
Kabelwinder om lange kabels weg te werken1 / 2

Wat heb je nodig?

Naast de geprinte onderdelen:

  • 2×Schroeven

Beschrijving van de maker

Origineel in het Engels

Edit: Updated the V2 base to make it easier to remove → V2.1

Installation

Attach the base with two screws. Then sling the cables around it and snap the cover in place.

Printing

I added a new version with wider clips that prints without supports. 

The base prints on the side. I used PETG for this part

The Cover prints as shown below. I used PLA for this part.

Geprint door de community

Bij de bron al 42 keer geprint. Laat hier als eerste zien hoe het bij jou werd.

Reacties 0

Log in om een reactie te plaatsen.

    Nog geen reacties. Heb je dit geprint? Laat weten hoe het ging.

    Ook handig in huis

    meer zoals dit