Intended to be FDM printed as a single piece with no supports required.

Designed for continuous watch bands but should also work with any watch band as long as the band width does not exceed 24mm otherwise the lower strap will interfere with the stand if wrapped towards the back. The charging puck fits relatively tightly so a small amount of force is needed to push into place. There is a cutout on the upper half that allows some compliance when pushing the puck in. 

Solid base is self explanatory. Alternate version allows insertion of multiple double stacked M5 nuts to increase the weight of the base.

(tabs) models include small single layer tabs to help with bed adhesion for some of the areas with narrow bed contact. They can easily be cut off after printing. If printing without the tabs it may be necessary to add a small brim.

Photos printed in black Polylite ABS, 0.4mm nozzle, 0.2mm layer height, 3 perimeters, 23% infill