The container lid closes very tightly and locks well in place, due to a tiny thread-like design at the end of the bayonet mechanism. This gives the outside of the container a very smooth appearance without any visible gap, while at the same time creates an almost water tight seal.

The mechanical margin between the lid and the pod is tested to work well when printed in PLA and in PETG. In the picture with the five pods, the clear and the dark blue pod is made from PETG, the others are PLA.

License:

The license does not allow derivatives, as one of my designs in the past was “taken” from me in the past to collect donations on Thingiverse via a “Remix”, that did not add any significant value. That made me really sad. If you want to seriously remix this design, please contact me and I will gladly approve that.