1 / 2Beschrijving van de maker
Origineel in het EngelsAll printable parts for your Original Prusa XL. The parts are divided into folders based on subassemblies.
Print instructions
- ATTENTION: Two materials (PETG and Polycarbonate) are recommended for the printable parts. Read the following list carefully.
- Download the latest PrusaSlicer
- For 0.6 nozzle
- Parts from PC Blend Carbon Fiber
- print settings**: 0.25mm QUALITY, 4 perimeters, 30% Grid infill
- list of parts:
- x-carriage
- y-carriage-left-base
- y-carriage-left-top
- y-carriage-right-top
- y-carriage-right-base
- entry-fs-insert
- fan-shroud
- dock-cable-router-parking-plate-cap
- dock-cable-router-parking-plate-support
- Parts from PETG
- print settings**: 0.25mm QUALITY, 15% Grid infill
- list of parts:
- all the parts except the ones mentioned above
- Parts from PC Blend Carbon Fiber
- For 0.4 nozzle
- Parts from PC Blend Carbon Fiber
- print settings**: 0.20mm STRUCTURAL, 4 perimeters, 30% Grid infill
- list of parts:
- x-carriage
- y-carriage-left-base
- y-carriage-left-top
- y-carriage-right-top
- y-carriage-right-base
- entry-fs-insert
- fan-shroud
- dock-cable-router-parking-plate-cap
- dock-cable-router-parking-plate-support
- Parts from PETG
- print settings**: 0.20mm STRUCTURAL, 15% Grid infill
- list of parts:
- all the parts except the ones mentioned above
- Parts from PC Blend Carbon Fiber
** Note that print settings are recommended, but you can experiment with your own.
Geprint door de community
Bij de bron al 115 keer geprint. Laat hier als eerste zien hoe het bij jou werd.
Reacties 0
Ook handig in 3d-printer
meer zoals dit
Extern
Extern
past op Bambu Lab P1, X1, X1C
past op IKEA Lack
past op Prusa i3 MK3 / MK23D-printer
Verstelbare Raspberry Pi-camerahouder voor Prusa MK3 en MK2
door Sneaks
PETGgeen support
28k 695
past op Prusa MK3S3D-printer
Standaard voor twee tot vier Prusa-printplaten
door iFreyz
PLAgeen support2 u 47 min
19k 935