Naar de inhoud
Inloggen
Raspberry Pi 4-behuizing voor op de Ender 31 / 6

Wat heb je nodig?

Naast de geprinte onderdelen:

  • 1×Raspberry Pi 4
  • 1×CanaKit-ventilator

Beschrijving van de maker

Origineel in het Engels

I upgraded from a Raspberry Pi 3 to a 4 and could not find an existing case that I liked, so I modified the Pi 3 case from giacomo30196 (https://www.thingiverse.com/thing:3016364) that I had been using for years. This was designed to hold the CanaKit fan that comes with their Raspberry Pi 4 bundles. No supports are needed. You could use screws to hold the halves together, but I find friction fit is enough.

Updated 7-27-22
Several variations of camera ribbon, display ribbon and gpio pin ports have been added for the top part.

Geprint door de community

Bij de bron al 16 keer geprint. Laat hier als eerste zien hoe het bij jou werd.

Reacties 0

Log in om een reactie te plaatsen.

    Nog geen reacties. Heb je dit geprint? Laat weten hoe het ging.

    Ook handig in 3d-printer

    meer zoals dit