I needed a mount to get my Blink Sync Module 2 (cumbersome name) off my desk without mounting it to the wall. Everything I found was at an odd orientation and/or did not have a cutout for the USB memory module I added.

I used this short, right-angle USB cable from Amazon to connect the two so there isn't a lot of slack I had to deal with.

A couple of notes about this print. The tolerances are pretty tight on the plug and kind of free on the Sync Module. Depending on the calibration of your printer, you may need to bump the scale up or down a little bit to get things to fit for you.

Also, I HAD to put the block in from the back because, strangely enough, the block is larger on the plug end than it is in the front.